Suppose a temporary clean-water drainage job has to lift water from a lower floor to a high outlet. There is a safe intermediate landing, but neither available pump can deliver the required flow through the whole rise and hose. An open intermediate tank can break the lift into two independent jobs. Select each pump at its own working head, then size the tank for the difference between incoming and outgoing flow. Two pump nameplates added together cannot tell you how long that tank can operate without overflowing or running low.
The open water surface separates the duties
The lower pump discharges to the break tank through a secure connection suited to the installation. The tank has an atmospheric water surface. The upper pump draws from that tank and sends water along its own hose to the final outlet. At steady operation, the first pump does not directly pressurize the second pump’s intake. Each sees its own starting water level, hose friction, fittings and receiving condition. Check whether high hose points introduce extra starting lift and whether the final outlet can become submerged. Even if each leg has half the elevation rise, a long narrow hose on one leg can make its duty harder than the other.
Make a sketch with the lowest expected source level, the high and low tank levels, and the final receiving level. Specify both pump duties over these ranges. Size and support the tank for its full water weight and place it where an overflow can be handled safely. A tank on an intermediate floor is a substantial load; use a location approved for the filled weight and keep service access clear. A closed or inadequately vented vessel is a different design. Do not plug a vent or connect two pumps directly in pressure series to imitate this arrangement.
Use the volume between real control levels
For an example, suppose pump A supplies 75 litres per minute and pump B delivers 60 litres per minute under their respective installed duties. While both operate, the tank gains 15 litres per minute. If 90 litres are available between the usual running level and the high stop, the simplified fill time is six minutes. If B fails to start, the same 90 litres could be filled by A in about 72 seconds. The second result matters for the high stop and overflow path. Verify the volume between control marks using the tank shape or a fill calibration; the tank’s total capacity includes water below the low stop and freeboard you cannot use.
If B delivers more than A, the tank will fall. Its low-level stop must act before the intake draws air or the motor loses permitted cooling. If A can send water while B is out of service, use a receiving high-level stop or an approved interlock, and provide a safe overflow appropriate to the consequence of a failed stop. Allow for delay, water that drains from a hose after stopping, and restart behavior after power loss. The specified float separation also has to provide a reasonable run and rest cycle for both pumps.
Test a failure sequence before leaving it in service
With clean water and the drainage operator in control, confirm each leg alone at a representative duty. Then run both and log the tank level versus time. Have qualified staff simulate an unavailable upper pump by the approved control method; confirm that the incoming flow stops in time and the overflow route is usable. Check the reverse case, in which the incoming leg stops and the upper pump reaches its low stop. Restore ordinary control and verify that a later refill does not require someone to reach into the tank or defeat a switch. Do not run a pump dry or deliberately flood a room for the test.
A relay can make a high lift feasible, but it adds a vessel, two sets of controls and more points requiring inspection. For a continuous installation, the site’s electrical protection, structural loading and flood contingency need design approval. A useful acceptance sheet shows both duties, the working tank volume and what happens when either leg stops. That is more informative than a promise that two pumps can lift twice as high.
Frequently asked questions
Must both pumps be identical?
No. Match each leg to its own duty and check the tank’s volume balance. Identical models can still deliver different flows through different hoses.
Can a larger tank make up for a permanently slower upper pump?
Only temporarily. A persistent difference needs a change to flow, control or operating sequence.
Does the break tank remove the need for low-water protection at the original source?
No. The lower pump still needs the correct operating conditions and protection for its own source.
