Two bags of black O-rings arrive with the same measured Shore hardness. One was ordered in a specific compound for a pump seal; the other has an uncertain label. Can incoming inspection distinguish them? Often it can screen for a mix-up using traceability, a retained control sample, density and an infrared fingerprint. Identifying a broad polymer family is easier than proving that every property of the specified compound matches.
Start with the identity trail
Check supplier part number, drawing revision, compound designation, lot and the link between the bags and the batch document. Verify dimensions and markings that the purchase specifies. A broken label chain is a receiving problem even if the samples look right. Keep bags separate and preserve a sealed example from each suspect lot. Compare against a retained, traceable approved sample made to the intended specification. An unidentified ring from the service bench is a poor control.
Hardness measures an indentation response under prescribed conditions. Different recipes can produce similar values, and ring size, geometry, temperature and method can affect the measurement. Density adds an independent screen because ingredients and fillers influence mass per volume. An apparent match does not prove identity. Set screening limits with the supplier and lab, and consider measurement uncertainty before treating a small difference as a defect. A dimensional or density mismatch may be useful grounds to isolate stock while checking identity.
Know what an infrared fingerprint can resolve
Fourier transform infrared spectroscopy compares the light absorption pattern associated with chemical groups. The laboratory can compare characteristic features with the approved control and a suitable library. The compound’s fillers, additives, contamination and aging may affect results. An attenuated total reflection measurement primarily samples near the surface. Surface treatments, lubricant or an altered surface can complicate interpretation; ask the lab to choose the approved preparation and interpretation. Do not scrape or solvent-clean all retained samples in receiving, because this may destroy evidence of the original condition.
In an illustrative investigation, two lots have the same hardness within test variation. One differs clearly from the approved control in multiple infrared features and density. That is enough to hold it pending confirmation of identity. Another lot has a similar fingerprint but a different response to an approved liquid exposure test. A shared base polymer or a similar spectrum cannot settle swelling, compression behavior or compatibility.
Choose a release rule that matches the risk
Routine inspection can use documents and agreed physical screens, with lab analysis triggered by uncertainty, a supplier change or a higher-risk application. For suspected mixing, identify how the sample was drawn and how much of the lot it represents. One matching item cannot clear a mixed bag. If identity or performance remains uncertain, quarantine the stock and seek a traceable supplier disposition or an agreed additional test. Retain the source lot data and link it to affected pump batches if any rings were already used.
The final release decision should address the actual seal function and any specified immersion, temperature or compression checks. Use laboratory screening to answer the right question: which lots might differ from the approved compound, and which need more evidence before use?
Do not discard a conflicting screen because another result matches. If density and spectrum point in different directions, review sample preparation, measurement conditions and where the spectrum was taken. Retest an original specimen and the traceable control with the same method. Ask the lab to distinguish an analytical finding from a pass or fail decision under the purchase specification.
Frequently asked questions
Can I identify a rubber family by black color?
No. Pigments and fillers can make many compounds look similar.
Does a close infrared match confirm the exact recipe?
No. It may support similarity in selected chemical features, but not every ingredient, ratio or functional property.
Can I clear a whole bag using one matching ring?
Only an agreed sampling plan can define what a sample represents. Investigate any evidence that lots were mixed.
